How do you connect a DC inverter to a switch?

Insert the wire into the round opening and remove the screwdriver – the wire is automatically clamped. You can connect systems with multiple DC strings in parallel to the DC input terminals of the switch. Inverters have one, two or three pairs of DC input terminals, depending on the inverter power rating.

How do I activate the inverter?

1. Turn ON the AC circuit breaker on the main distribution panel. 2. Open SetApp and follow the on-screen instructions (scan the inverter bar-code; move the ON/OFF/P switch to P position for 2 seconds and release). SetApp creates a Wi-Fi connection, upgrades the inverter firmware and activates the inverter. 3.

How do I set up my inverter?

Menus may vary in your application depending on your system type. During first time installation: Upon activation completion, in the SetApp, tap Start Commissioning. If not already ON - turn ON AC to the inverter by turning ON the circuit breaker on the main distribution panel.

How do you connect an inverter to a house?

Connect output wires: Connect the output wires of the inverter to your house wiring. This can be done by connecting the inverter’s output terminal to the main distribution board or to specific circuits or appliances that you want to power.

How do I Commission my inverter?

Perform the commissioning steps as described in Chapter 5: Activating, Commissioning and Configuring the System . Turn OFF the inverter ON/OFF/P switch, and wait until the green LED is blinking, indicating that the DC voltage is safe (<50V), or wait five minutes before continuing to the next step.

How do you ground a DC inverter?

Use 16-6 AWG, 75-90°C copper wires only. Equipment grounding: Connect the DC equipment ground conductor to the equipment grounding terminal block in the Safety Switch. Functional Electrical Earthing of DC-side negative or positive is prohibited because the inverter has no transformer.