Most solar installations require an electrical and/or building permit. Determine if your utility requires an interconnection agreement to connect your solar system to their grid. Contact them early in the process. Decide between a DIY or professional install.
[pdf] The Renewable Energy Ready Home (RERH) specifications were developed by the U.S. Environmental Protection Agency (EPA) to assist builders in designing and constructing homes equipped with a set of features that make the installation of solar energy systems after the completion of the home’s construction. .
These specifications were created with certain assumptions about the house and the proposed solar energy system. They are designed for builders. .
EPA has developed the following RERH specification as an educational resource for interested builders. EPA does not conduct third-party verification of the. .
Builders should use EPA’s online RERH SSAT to demonstrate that each proposed system site location meets a minimum solar resource potential. EPA has. .
The builder should install a 1” metal conduit from the designated inverter location to the main service panel where the system is intended to be tied into the home’s.
[pdf] Solar panels should be mounted at a height of 3.75″ to 5.25″ from the roof’s surface to ensure optimal performance. This measurement takes into account the seam of the SSMR, typically 1.5″ to 3″ in height, the mounting hardware, adding approximately ¾” and the module frame, contributing another 1.5″.
[pdf] 
